DPB

Watch and learn how to easily clean your LINAK desk panel/switch in this short instruction video: How to clean it; which cleaning agents to use; and, last but not least, what you need to pay attention to.

Clean your desk panel with a soft damp cloth. Universal cleaning detergents may be used.

To disinfect the desk panel, use a 70% isopropyl alcohol either as a wipe or add a small amount to a soft cloth.

Warnings
The desk panel is not a sealed unit and there are electronics inside it. If liquids or moisture get into an opening, the PCB may be damaged, and the desk panel ruined.

So:

• Avoid moisture penetrating any openings as this may damage the PCB inside the desk panel
• Avoid spraying the cleaning agent or disinfectant directly on the desk panel as moisture may penetrate openings, damaging the PCB inside the desk panel
• Cleaning agents and disinfectants must not be highly alkaline or acidic (pH value must be 6 to 8), and they must not contain bleach or chlorine
• Do not use hand sanitiser gel as a cleaning agent

Alkaline and acidic cleaning agents may, over time, decompose the housing. Hand sanitiser gel may deposit on the desk panel buttons. Over time, the buttons may get stuck, or they may not work properly.

To watch our videos, please accept the marketing cookies

The desk cannot be raised if it has not been initialised.

If error code 'E01' is shown in the display, the desk must be initialised.

How to initialise your desk:

1. Press the down key until the desk is lowered completely. Hold the key until the desk no longer moves.
2. Reactivate the down key and hold until the desk no longer moves.

Now the desk can be raised.

To watch our videos, please accept the marketing cookies

The desk needs to be initialised.

Follow the procedure shown in the video.

To watch our videos, please accept the marketing cookies

Possible problem: Mains not connected to the control box
Try/Solution: Try to connect a lamp or similar to the mains supply to check whether there is adequate supply voltage. 

Possible problem: Are plugs mounted correctly in the control box or to the leg?
Try/Solution: Check all connections. 

Possible problem: Are there any visible damages on cables, controls, the control box or legs?
Try/Solution: Damaged parts must be exchanged. Contact the company that sold you the desk. 

The system has set a new end-stop outwards.

To reset a saved position, the desk must be re-initialised. Follow the procedure shown in the video.

To watch our videos, please accept the marketing cookies